Rogue One Torch Simple Shell to fit a torch inside.

I have had a few request about the Rouge One torch and after some discussion with interested parties here is the design.

I have made a few modifications for ease of installment. Bellow is a picture of the actual helmets in storage you can see the torch is held in place by wire, So I have replicated the system to attach to the shield.

Below is the wire set up that you can use to install your torch to your helmet shield. Note this is a different torch set up. You will need 1-1.2mm wire to slide inside the 2 holes of the torch to secure it to the helmet shield.

Type of torch that will fit inside the print any torch that has diameter of 15mm and a maximum lenght of 98mm, here is a link to the torch in the picture.

Finished torch on the Rebel Helmet.

Here is an older post about priming and painting the 3d printed torch.

The torch shell will be available at shapeways and my minifactory page (there are 2 torch designs there).